Microweb PRO Series Spécifications télécharger pdf (Page 41)

Mounting and Basic Deployment

2-15

4. Push the device, while holding the rail release open, into the rack until the front

of the device is flush against the front rack posts.

FIGURE 2-10. The appliance with rail attached

5. Twist the sun screws until tight to prevent the device from sliding in and out of

the rack.

Attaching the Rubber Feet for Freestanding Installation

For freestanding installation, ensure that the device has at least 2-inch (5.08cm) of

clearance on each side to allow for adequate airflow and cooling.

Use the pre-die-cut rubber feet that came with the device for a freestanding

installation. The rubber feet come pre-die-cut on an adhesive sheet. Remove each

rubber foot as needed being careful not to touch the adhesive surface. Stick the

rubber feet to the bottom of the device within 1-inch of each corner.

Thumb screw —used to stabilize

the device in a rack

Rail release—allows

the appliance to be

slid out of cabinet

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 101 102

Pas de commentaire

Microweb PRO Series Spécifications Page 41